Our NEW MicroDrive 2004

This 2-Cell 1W LED Drive module was designed to power (1) 1 Watt Luxeon®, or strings of 5mm (T 1-3/4) LEDs efficiently and with stability. This driver has been designed to provide maximum illumination to the LED while still mimicking the light drop-off of an incandescent bulb, which dims as the batteries are used up. Unlike an incandescent bulb, the driver's current consumption drops at very low voltages, allowing usable light to be produced much longer than conventional flashlights. Battery recovery (after the flashlight has been turned off) is also improved. Average on time is 4-6 hours.

The standard offering is a 0.45"L X 0.3"W X 0.26"H encapsulated microunit The unit is supplied with 24 AWG 6" colored leads.

Applications include 2-Cell flashlights, drop-in replacement bulbs for 2-Cell PR based lamps, pen lights, solar powered lighting, road markers and signal flasher units.

Operating Specifications

Voltage	Min	0.8 VDC
	Max	3.0 VDC
Power Consumption	Max	1.5 Watts
Driven LEDs per channel	1	1W Luxeon
or	12	5mm InGaN
Current output	Min	--- mA
(fixed)	Max	375 mA
Efficiency	Min	70%
(80% typical)	Max	85%

Key Benefits of the 2009 LED Drive Module:

Cost: The 2004 represents a low cost, small
option for providing current to LEDs with forward voltage in excess of the supply voltage.
Longevity: The 2004's output follows the voltage
of the batteries, but in a manner that provides more light during the mid-life of the batteries The unit
can turn on with as little as 0.8V.
Design ease: Ask about our matching array designs for use with this product.
Safety: The unit is surrounded by isolative
epoxy and is water resistant. The unit is short circuit and open circuit tolerant.

Applications for the 2009 - 2Cell 1Watt LED Drive Module

$14.95 Ea.